Black Widow 1R / 2-BUTTON SERIES Manual de usuario descargar pdf (Pagina 7)

7

Test System and Adjust Shock Sensor

Arm and disarm system, checking that the

siren chirps and parking lights are

functioning normally. Make sure that the

programmed features are performing

correctly, such as ignition locks, passive

arming, etc.

Test the doors and hood/trunk inputs

(make sure all doors trigger the system,

not just the drivers door).

Adjust the shock sensor.

Arm the system and try starting the

vehicle, it should not start.

Arm the system and disarm it with the

ignition and valet switch.

If programmed to passively arm make sure

that the system arms properly.

Tie up wire harness,and replace any under

dash panels.

Make sure the customer has physical

knowledge of the location of the

valet/override switch.

Adding Transmitters

To add a new transmitter to the system

have the desired transmitters ready and

follow the Code Learning sequence.

To enter Code Learning Mode:

1. Turn the ignition on, off, on, off and

leave on.

• The siren will chirp once.

2. Press and hold the Valet switch for 5

seconds.

• The siren will chirp 3 times.

3. Press the Lock Button on the

transmitter.

• The siren will chirp once.

4. Repeat step 3 for each additional

transmitter (max 3).

5. Turn off the ignition.

• The siren will chirp once.

NOTE: If a transmitter is lost or stolen, make

sure to code all 3 transmitter memory

locations. (Example: If only one transmitter is

used, repeat step 3 two times to remove any

previously programmed transmitters.)

BW1900.qxd 7/1/2005 4:16 PM Page 7

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Comentarios a estos manuales

Sin comentarios