5
activate the vehicle’s horn when the alarm is
triggered.
• BLACK/WHITE WIRE - Dome Light
output (-) 500mA. Connect to an optional
relay to activate the vehicle’s dome light.
• BLUE WIRE - Trunk/Hood trigger (-).
Connect the Blue wire to the trunk and/or
optional hood pin switches.The switch must
provide a ground output when switch is
opened.
• GRAY WIRE - Auxiliary output (-) 500mA.
Connect to a relay for an optional feature
such as trunk release, etc.
• YELLOW WIRE - +12V Ignition input.
Connect to a main ignition wire at the
ignition switch harness. This wire shows
+12V when the ignition is on and while
cranking. The voltage must not drop when
the car is starting.
• BLACK WIRE - Ground input (-). Connect
to a solid chassis ground that is clean and
free of paint or dirt.
• VIOLET WIRE - Positive door trigger (+).
Connect to the door switch circuit wire that
shows +12V when the door is open. This
type of door circuit is usually found on Ford
vehicles.
• GREEN WIRE - Negative door trigger (-).
Connect to the door switch circuit wire that
shows ground when the door is open.
Plug in Connectors
3-Pin White Door Lock Connector: Plug-
in connector for door lock harness or
optional door lock relay module.
• BLUE WIRE - unlock output (-) 500mA.
• RED WIRE - +12V output (+) 300mA for
relay modules, or inverters. Do NO
T use as
a power source for door lock relays.
• GREEN WIRE - lock output (-) 500mA.
2-Pin Red Connector: Plug-in connector
for LED. Mount LED in an area where it
may be easily seen from either side of the
vehicle.
2-Pin Blue Connector: Plug-in
connector port for valet switch. Mount
switch in an area easily accessible from the
driver’s seat.
4-Pin White Connector: Plug-in
connector port for dual stage shock
sensor.
Entering Programming
To enter System Programming:
1. Turn on ignition.
2. Within 5 seconds, press valet switch 5
times.
• The siren will emit a long chirp, to
indicate entering program mode.
3. Press the valet switch the number
times equal to the desired feature.
• The siren will chirp each time the
valet switch is pressed.
4. Within 5 seconds, press the
transmitter button corresponding to
the desired operating mode for that
feature.
• The siren will chirp to indicate the
setting.
1 chirp = Button 1 (default setting)
2 chirps = Button 2
3 chirps = Buttons 1&2
5. Turn off ignition to save changes.
BW1900.qxd 7/1/2005 4:16 PM Page 5
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales